Motor Limiting Table - RK Rose+Krieger SQZ-II Notice D'assemblage

7. Working life

7.2.5 Motor limiting table

Linear unit SQZ-II/SQZ-III
Version
SQZ-II 30
SQZ-II 40/SQZ-II 40 × 80
SQZ-II 60/SQZ-II 60 × 20
SQZ-III 80
SQZ-II 80 ×160
SQ-II-MT
Version
SQZ-II-MT 60/SQ-II-MT 60 × 120
SQZ-II-MT 80/SQ-II-MT 80 × 160
Transfer units
Linear units arranged in parallel must be matched to the transfer shaft to transfer torques. This
can - just as with the motor - be fixed to the steering with couplings, depending on the version.
If the designed installation length is greater than the maximum installation length or maximum
speed determined from the "estimated shaft design" formula, then a stationary bearing support
is used to absorb the corresponding loads.
Estimated shaft design:
max. installation length [mm] = (2720 - speed [min-1]) + 2 x 107.5
max. speed [min-1] = 2720 - L [mm]
The interface combinations determined by RK Rose+Krieger GmbH from coupling and transfer
unit are binding.
Steering
64
Max. motor weight in kg
Max. motor weight in kg
without protection
Centre of gravity distance
8
8
16
16
16
Centre of gravity distance
16
16
with protection
Stationary bearing
support
in mm
250
300
400
400
400
in mm
400
400
Steering