Motor Limiting Table - RK Rose+Krieger S Clean Notice D'assemblage

7.2.5 Motor limiting table

Version
RK DuoLine S 60 Clean
RK DuoLine S 80 Clean
RK DuoLine Z 60 Clean
RK DuoLine Z 80 Clean
* Distance from the mounting surface of the motor adapter to the mass centre of gravity.
Transfer units RK DuoLine Z 80 Clean
Linear units arranged in parallel must be matched to the transfer shaft to transfer torques. This
can – just as with the motor – be fixed to the steering with couplings, depending on the version.
If the designed installation length is greater than the maximum installation length or maximum
speed determined from the "estimated shaft design" formula, then a stationary bearing support
is used to absorb the corresponding loads.
Estimated shaft design:
Max. installation length [mm] = (2720 - speed [r.p.m.]) + 2 x 107.5
Max. speed [r.p.m.] = 2720 - L [mm]
The interface combinations determined by RK Rose+Krieger GmbH from coupling and transfer
unit are binding.
without protec-
Version
Standard or synchronous
Stationary bearing support
Deflection
Max. motor weight in kg
8
16
8
16
with protec-
Deflection
7. Life Phases 7. Life Phases 7. Life Phases
Centre of gravity distance
in mm
Standard design
Clamping hub
Synchronous design
Clamping hub
300
400
300
400
Clamping hub
Clamping ring
57 57 57