Floating Bearing Side Marking - RK Rose+Krieger PLZ-II Notice D'assemblage

7. Working life
Spindle lubrication
The spindle is lubricated via the front face of the guidance slide. To do this, the guidance slot is
driven out from the drive side to the rear end position. The grease is fed via the grease nipple 1 to
the grease nut 2 and distributed in small quantities on the spindle.
Grease in two stages. After the first stage, drive the guide slides through two slide lengths and
then top up with the second stage.
Recommended lubricating interval taking the environmental factors and loading data specified in
these assembly instructions into consideration.
Relubrication:
every 300 km / 2 sub-quantities for each 2.0 cucm
Recommended lubricants:
Grease in accordance with DIN 51818
2
Viscosity class:
NLGI class 1
1
NLGI class 00
For use in max. range:
Grease in accordance with DIN 51818
Viscosity class NLGI class 2

7.4.1 Floating bearing side marking

The floating bearing side for a linear unit of the "Roller" type
is marked with a sticker at the factory.
The position of the marking can vary.
62