Safety Signs; Obvious Danger Points On The Linear Unit - RK Rose+Krieger PLZ-II Notice D'assemblage

5.3 Safety signs

These warning and command signs are safety signs which warn against risk or danger.
Information in these assembly instructions on particular dangers or situations on the linear unit is
to be obeyed, as failure to do so increases the risk of accident.
The "General Command Sign" instructs you to be observant.
Special attention should be paid to marked information in these assembly instructi-
ons.
It provides you with important information on functions, settings and procedures.
Failure to obey may lead to personal injury and faults on this controller or damage to
the environment.
The "Hot surface" warning sign warns against injuries from hot surfaces.
The "Danger of drawing in" warning sign warns against points on this product whe-
re there is a danger of being drawn in.
The warning sign "Danger! Hand injuries" warns that hands may be crushed, drawn
in or injured in some other way.
The warning sign "Danger! Risk of cutting" warns against injury to the hands.
This symbol marks the loose bearing side of the guide slide on linear units of the
"Roller" type.

5.3.1 Obvious danger points on the linear unit

PLS-II linear unit with 2 slides
Right and left hand thread
PLZ-II linear unit
5. Safety
47