Installing The Optional Accessories - RK Rose+Krieger PLZ-II Notice D'assemblage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7. Working life
PLS fixing component
The PLS fixing component 1 encloses the end component of
the linear unit and is bolted to the base.
1

7.2.4 Installing the optional accessories

Mechanical or inductive limit switches
The technical specifications for limit switches can be found in the catalogue. Ensure that the wir-
ing is safely laid out during installation. Avoid damage to the wiring, for example by having radii
that are too small, as this can lead to failure of the system. The wiring must not be in the path
travelled by the linear unit.
Mechanical limit switch
The limit switch is installed at its position on the side of the
guidance section of the linear shaft with a support plate. The
groove running in the side of the guidance section is used to
secure the switch at the desired switching point position. The
fixing kit is enclosed with the part.
Inductive limit switch
The inductive limit switch is clamped firmly to the guidance
section at the fixing mountings. The limit switch can be
moved. To install it, move the switch in the groove until the
switching point is reached. Use a tapped pin to secure the
proximity switch in the groove.
57

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Plz-i-iiPls-iiPl-ii

Table des Matières