Maintenance And Disposal; Maintenance; Disposal; Technical Characteristics - Nice Tub Instructions Et Recommandations Pour L'installateur

6) Maintenance and disposal

This chapter provides information about how to draw-up a mainte-
nance schedule, and the disposal of the TUB3500.

6.1) Maintenance

The automation must be subjected to regular maintenance, in order
to guarantee it lasts and to maintain its level of safety.
!
The maintenance operations must be performed in strict
compliance with the safety directions provided in this manual
and according to the applicable legislation and standards.
If other devices are present, follow the directions provided in the cor-
responding maintenance schedule.
1. TUB3500 requires scheduled maintenance work every 6 months
or 10,000 manoeuvres (max.) after the previous maintenance:
2. Disconnect all power supplies

6.2) Disposal

TUB3500 is constructed of various types of materials, some of which
can be recycled: steel, aluminium, plastic, electric cables; while oth-
ers must be disposed of.
!
Some electronic components may contain polluting sub-
stances; do not pollute the environment. Enquire about the
recycling or disposal systems available in compliance with
regulations locally in force.
1. Disconnect the power supply of the automation system
2. Disassemble all the devices and accessories, following in reverse
order the procedures described in chapter 3 "Installation".

7) Technical characteristics

Nice S.p.a., in order to improve its products, reserves the right to modify their technical characteristics at any time without prior notice. Inany
case, the manufacturer guarantees their functionality and fitness for the intended purposes.
All the technical characteristics refer to a room temperature of 20°C (±5°C).
Technical characteristics: TUB3500
Type
Pinion
Peak thrust
Nominal torque
Nominal torque speed
Maximum frequency of operating cycles
Maximum continuous operating time
Operating limits
Power supply
Max. absorbed power
Insulation class
Operating temperature
Use in particularly acidic or saline
atmospheres or potentially explosive
Protection level
Dimension and weight
Other technical characteristics are indicated in the A500 control unit instructions
8
3. Check for any deterioration of the components which form the
4. Check the wear and tear on the moving parts: pinion, rack and
5. Connect the electric power sources up again, and carry out all
3. Wherever possible, separate any parts which can or must be
4. Sort the various materials and consign them to local licensed
Electromechanical self-braking gear motor for the automatic movement of sliding gates for industrial
use, complete with electronic control unit
Z= 18; Module =6; Pitch =18.8; Pitch diameter =108mm
418Nm; corresponds to the ability to start a leaf moving with a maximum static friction of 7740N
190Nm; corresponds to the ability to keep a leaf with a dynamic friction max. 3520N moving.
0.167m/s (10m/min)
200 cycles/day
30 minutes (the control unit foresees a maximum operation time of 120 seconds which can be
modified to 210 seconds).
TUB3500 is generally capable of automating gates up to 3500 Kg in weight and 30 m in length.
Three-phase 400V ac +/-10%; 50Hz.
550 W
1 (a safety earthing system is required)
-20°C ÷ 50°C
No
IP 44
580X480X240; 60Kg
automation, paying particular attention to erosion or oxidation of
the structural parts. Replace any parts which are below the
required standard.
the leaf components; if necessary replace them.
the test and checks foreseen in Paragraph "5.1 Testing".
recycled or disposed of in different ways, e.g. metal parts must
be disposed of separately from plastic ones, as must the elec-
tronic cards etc.
firms for recovery and disposal.