Fitting Instructions - Module 2, Liquid Dispensing - Miele MF02 10 Notice De Montage

Produktgruppe 512
7 von 40
en
Parts required
Quantity Mat. no.
1 09079450
Note
This service and repair work should only be carried out by a suitably qualified electrician (with specialist training, knowledge and
experience, and recent related work experience) in accordance with all appropriate local and national safety regulations.
Commissioning, servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance
with all appropriate legal requirements, accident prevention regulations and valid standards. All regulations of the appropriate utility
supply companies and standards relating to safety (not limited to electrical safety) are to be complied with.
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable measurements must be made to
ensure that this is the case.
A general visual check and risk evaluation should always be carried out.
Incorrect conversion or service work can be dangerous (risk of fire, electric shock, etc.).
Danger!
Correct earthing function can be deactivated if casing parts are incorrectly assembled.
Correct earthing function must be ensured when refitting the casing.
Carry out appropriate electrical safety checks.
Danger!
During fitting, all accessible conductive parts that are not connected to the earth must not have any link to earth (strengthened double
insulation).
To confirm this, insulation resistance and touch current measurements must be carried out.
Note
The kit, Mat. no. 09079450, for PW 6107, PW 6137, PW 6167 and PW 6207 contains the following:
1 electronic module EZL 235, module 2 (liquid dispensing 7 - 12)
4 spacers (for electronic module EZL 235 fastening)
1 coding plug MFM 2-5 (module 2 EZL 235 - Plug connector ST3), PIN 2-5
1 wiring harness 20X-41X (module 2 EZL 235 - Plug connector ST10 / module 1 EZL 235 - Plug connector ST9), plug housing,
3-pole, 500 mm
1 wiring harness N1Q_ST112, N1Q_ST11 (module 2 EZL 235 - Plug connector ST111 / module 1 EZL 235 - Plug connector
ST112), plug housing, 4-pole, 350 mm
3 connection wires, black 0.75 x 90
1 screw connector strip, 6-pole, blue
1 screw connector strip, 7-pole, green
1 terminal strip 1X3-4, orange
1 terminal strip 2X3-4, grey
1 terminal strip 3X3-4, blue
1 terminal strip 4X3-4, green/yellow
1 accessory module
1 wiring diagram PW 6107 - PW 6207 module 2, Mat. no. 09021420
Fitting instructions - Module 2, liquid dispensing 7 - 12, Mat. no. 09087210.
10.02.2012 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Fitting kit - MF02 10-20 multifunction module PWxx7
M.-Nr. 09087210