Installation; Schematic Diagram Showing The Dos Module; Installing The Dos Module; Suspended Installation - Miele Professional DOS G 80 Notice De Montage

Suspended

installation:

Flat
installation:

Schematic diagram showing the DOS module

Installing the DOS module

The DOS module is supplied with two screws (4.2 x 25 mm) and two
plugs (6 mm) for installation.
Select a suitably accessible position, e.g. on an adjacent wall or in

a unit for installing the DOS module.
Using the drawing as a guide fit the screws the correct distance

apart (80.0 mm) and suspend the DOS module from these.
Two slots, 76.0 mm apart are provided at the bottom of the DOS
module for fixing the DOS module to a thin carrier or plate. 3.9 mm
diameter screws (not supplied) are required for securing the DOS
module.
Drill two holes through the plate and screw the DOS module firmly

in place from underneath.
en - Installation
37