Connecting The External Time Signal - Lathem 5000E Plus Guide De L'utilisateur

Connecting the External Time Signal

CAUTION: Be sure to pull out AC cord from AC outlet before connecting wires of the
External Time Signal.
Improper connection may cause a malfunction of the unit.
Also refer to "Attaching the Wire Clamp" to secure wires with the wire
clamp.
1
Unlock the key and remove the cover.
2
The connector for external time
signals is on the back of the Time
Recorder.
connector
53
3
Insert wires into two right terminals
for external time signal, and tighten
both screws.
4
Replace the cover and lock.
Connection Specifications
External Contact
• Contact output: One circuit,
dry contact
• Contact capacity: 5A, 30V
for
54