Features Menu - Philips 30PF9946D/37B Mode D'emploi

2355.4 en 02-11-2004

Features menu

Features
Timer Sleep
AutoLock π Time
Contrast+ Start Time
DNR
PIP
Timer
This menu lets you use the TV set as an alarm.
& Press the
MENU
é
With the cursor, select
"
Time : enter the current time with the digit
buttons.
Use the cursor left/right to select and to toggle
AM or PM.
'
Start Time : enter the start time.
( : enter the standby time.
Stop Time
§
Channel No : enter the number of the channel
for the wake-up alarm.
è
Activate : the settings include:
• Once for a single alarm;
• for each day,
Daily
• to cancel.
Off
!
Display : press the cursor right to select On or
Off, according to if you want to display the
current time on the TV screen or not.
ç Press the B button on the remote control to
put the TV set in standby. It will automatically
come on at the time programmed. If you leave
the TV set on, it will just change programs at
the time entered (and will go to standby mode
at the Stop Time).
Note: by combining the AutoLock and Timer
functions, you can restrict the period during which
the TV set is used, for example by your children.
10
14:19 Pagina 10
AutoLock
Block Channel Unrated
Lock HD No rating
Change Code Blocking
Clear All
Block All
Movie Rating
TV Rating
Block Options π
button.
, then
Features Timer
AutoLock
The AutoLock feature receives and processes data
sent by broadcasters or other program providers
that contain program content advisories.When
.
programmed by the viewer, the TV can respond to
the content advisories and block program content
that may be found objectionable.
AutoLock allows parents to block out or "censor"
any channels they think children should not watch.
A channel blocked cannot be viewed until a correct
access code is used to unlock the channel for
viewing.
&
Press the button.
MENU
é
With the cursor, select
AutoLock .
" Press the cursor right to enter the AutoLock
menu.
'
You are asked to enter your Access Code.
• Press 0,7,1,1 on the remote control.
will appear on the screen.
Incorrect
• Press 0,7,1,1 on the remote control again.
New Code will appear on the screen.
• Enter a new 4-digit code using the number
buttons.
Confirm Code
screen.
• Enter your new 4-digit code again.
will flash on the screen briefly
Confirmed
and the highlight bar goes back to Block
Channel.
Important: you have forgotten your
Access code
Remember that 0,7,1,1 is the default
AutoLock™code. If your access code has
been changed by someone other than you (a
child, for example) or you have forgotten the
code, you can always get in by inputting the
default code.
Features , then
will appear on the