Initial Operation - Winix HR1000 Mode D'emploi

INITIAL OPERATION

Insert the unit plug into an electrical outlet.
①
x The Control Panel lights will turn on and off.
Press the [Power] button.
②
▶ During the first 4 minutes of power up,
the Air Quality light will flash as the
Smart Sensors measure the air quality in
the environment, after which normal
operation will begin.
By default, when the unit first powers on, the mode will be set to Auto
③
with PlasmaWave® enabled.
x When in Auto Mode the fan speed will be automatically adjusted according to the
environments air quality.
x PlasmaWave® works to remove harmful airborne contaminants.
▶ In Auto mode, as the indoor air quality improves, the fan speed
will automatically be reduced to Low.
▶ When the unit is running, you may hear a chirping or buzzing
sound. The sound is from large particles passing through
PlasmaWave®, it is normal and does not signify product failure. To
disable PlasmaWave®, see page 11.
English
Operating the air cleaner
| Operation
9
HR 1000