Adjusting The Volume; Using Headphones; Playback Modes - TechniSat DIGITRADIO 1990 Mode D'emploi

- Access menu
- Navigate through the menu
- Save/Confirm changes
- Exit menu
The currently selected function/option is shown in square brackets < >. The
currently active function/option is shown with an asterisk *.
> To exit the menu, wait for a short time or press the INFO/MENU/MEMORY
button.

7.3 Adjusting the volume

To change the volume, use the buttons marked Volume on the device. To increase the
volume, press VOLUME + (11); to reduce it, press VOLUME - (10).

7.4 Using headphones

WARNING!
Do not listen to the radio at high volume with headphones. Doing so can
cause permanent hearing impairment. Turn down the radio volume to the
lowest volume before using headphones.
When you attach headphones (not in the scope of delivery), the device's speakers are
muted.
> Only use headphones with a 3.5 mm stereo jack plug.
> Insert the headphone plug into the headphone jack (21) on the side of the
device. Sound is now played exclusively through the headphones.
> If you would wish to use the speakers again, unplug the headphones from the
headphone jack on the device.

7.5 Playback modes

Your device has different possible reception routes for playback. These are described
below.
> To switch between the individual modes, briefly press the MODE/CLOCK
button (3).
The currently active playback mode is shown in the display.
The modes are:
DAB+ radio, FM radio, CD, USB, Audio In, Bluetooth.
50
- Keep the INFO/MENU/MEMORY button (5)
pressed.
- TUNING/SKIP button (6, 7).
- ENTER/STOP/SLEEP button (8).
- Keep the INFO/MENU/MEMORY button (5)