Robert Juliat 1011+ Dossier Technique page 51

robert
juliat
HOW TO ADJUST THE MAINS POWER INPUT.
1
208V 60Hz
245V 50Hz
220/240V 50Hz
- Make sure the unit is disconnected from the mains.
- Lay down the unit as shown in the diagram above.
- Unscrew 12 M4 x 8 screw 1 with a cross point screw driver.
Do not remove the 13
- Remove the cover towards the back.
- Now you can accede to the choke's terminal 2 .
- Do not remove the wires connected to the "0" position.
- Place the ring tongue terminal 3 on the voltage required.
- Make sure that all the nuts 4 are well tighten by using two 8 size spanners
for the M5 nuts.
- Make sure that the earth wire is still well connected to the cover 5 and to
the unit 6 .
- Replace the cover as explained for removing it, but in reverse order. Then
tighten the screws 1 .
- Display the correct voltage plate 7 , which corresponds to the voltage
that has been selected.
32
robert juliat
HMI 1200 FOLLOWSPOT
5
6
7
th screw found with the
TECHNICAL FILE
H M
I 12
00
20
20
/2 40
V. 50
H z
sign.
1011
1011
1011
A DATER DU:
VALID SINCE:
1
2
4
3
ROUTE DE BEAUMONT F 60530 FRESNOY - EN - THELLE
TEL.: 33 (0)3.44.26.51.89 FAX : 33 (0)3.44.26.90.79
+
+
+
B
08.12.97