Robert Juliat 1011+ Dossier Technique page 38

robert
juliat
OPERATION
THE POWER
SUPPLY UNIT
3
2
LAMP ON
30.23
1
AMONT ON OFF
MAINS FUSE
TELECOMMANDE /
REMOTE CONTROL
0 - OFF 0 - OFF
HMI 1200
220/240V 50Hz
1 Mains checklight.
2 "ON-OFF" switch.
3 Lamp ON,
checklight.
(Checklight 3 off).
LIGHTING UNIT
(Lantern alight).
(Checklight 3 on).
LIGHTING UNIT
24
robert juliat
HMI 1200 FOLLOWSPOT
NON-FUNCTIONING DIAGNOSIS.
SYMPTOMES
Checklight 1 does
not light up when the
power supply unit is
connected.
No light in the
The checklight 3 does
lantern side.
not light up when 1
is on.
Difficulty in lighting.
No light in the lantern side.
No light in the zoom side.
Bad quality light beam.
No air aspired or exhausted in the
lamphouse.
WARNING : Do not use the lighting unit if the fan is not working.
(Note: that the fan doesn't work until the lamp and checklight 3 are ON.)
TECHNICAL FILE
POSSIBLE CAUSES
Mains absence.
The switch is in "O"
position.
Automatic breaker and
transformer are OFF.
Badly adjusted Spark-
gap.
Bad contact. Harting plug
power supply / Lighting
unit.
Lantern doors are badly
closed.
Lamp is badly mounted.
Ignition failure.
(energizer, Spark-gap).
Colour changer unit
closed.
Gobo frame changer
badly positioned.
Iris cassette badly
remounted.
Mirrors and lenses not
in good condition.
fan is not working.
1011
1011
1011
A DATER DU:
VALID SINCE:
REMEDES
Check the mains and
cable connections +
electrical diagram,
refer to pages 6 & 15.
Repeat the operation,
refer to page 8.
Turn ON the automatic
breakers, refer to page 8.
Refer to page 10.
Check the connections,
refer to page 6.
Make sure the doors are
properly closed. Adjust the
position of the mini-circuit
breaker.
Refer to pages 8 and 9.
Refer to page 10.
Open colour unit at the
front of the lighting unit.
Check gobo frame.
Refer to page 11.
Refer to page 10.
Refer to page 6.
ROUTE DE BEAUMONT F 60530 FRESNOY - EN - THELLE
TEL.: 33 (0)3.44.26.51.89 FAX : 33 (0)3.44.26.90.79
+
+
+
B
08.12.97