Washing The Filter; Cleaning Of Cyclone Cone - Husqvarna DC 6000 Manuel D'utilisation

• Clean the air filter by placing it in a bag and shaking
the dust off. Do not use compressed air or any sharp
objects to clean the air filter as this can cause damage
to the filter.
• The filter is a conical shape and the wider section
should be at the top of the filter container.
• Replace the filter container in its guide groove on the
handle.
• Tighten the container using the clamping brackets.
• Connect the hose connector to the filter container.
• Screw on the handle with the knob.
Washing the filter
The filter is made of a polyester material and can be
washed with water as necessary. Change filter after 500
hours or after 6 months.
• In order to avoid destruction of the finish or ePTFE
membrane clean the filter elements with a gentle soft
jet of water. A strong/sharp jet will destroy the ePTFE
membrane. The cleaning can be supported by a soft
brush.
• Wash the filter elements from top to bottom. Avoid
rubbing or scrubbing on selected spots.
• Dry the filter elements carefully. Approximately one
week at a temperature of 15-20 °C, or at 70 °C during
16 – English
All manuals and user guides at all-guides.com
MAINTENANCE
•
NOTICE! Ensure that the filter is dry before refitting it.

Cleaning of cyclone cone

•
•
•
14 hours in the oven. It is important that they are 100%
dry.
After washing in above mentioned way, the filter
elements can be used again at low pressure drop. The
life time after washing is approximately 60-70 % of the
life time in new condition.
Remove the cyclone cone by turning it
counterclockwise.
Turn the cyclone cone over and empty the dust and
debris on the floor.
Inspect the gaiter inside the filter container and clean
if necessary.