Engine Start-Up; Controls Adjustment - EMAK MZ2065 Manuel D'utilisation Et D'entretien

ENGINE START-UP

Refer to the engine's Use and Mainte-
nance handbook for starting.
Notes on how to use the Motorhoe
Once engine is running, place the tines
on the ground and, whilst firmly keeping
hold of the Motorhoe, insert the draw
arm into the soil. Pull the forward gear
lever on the handlebar to allow the tiller
penetrate the soil. To move the Motorhoe
forward, slightly lift the tiller with the
handlebars. The draw arm must always
remain in the soil during work.
Uses: Light and average textured soil
working. Soil working (hoeing/breaking-
up). Soil tillage (weeding). Ploughing in
compost or fertilisers, etc.
Attention: The Motorhoe is not suitable
for working with soil covered by thick
grass/lawns. It is recommended not to
use the Motorhoe in stony soils.

CONTROLS ADJUSTMENT

Attention: The tiller must begin to turn
only affer having operated the corre-
sponding controls. This is obtained by
adjusting the wires (Fig. 8 details 2) and
the control levers.
Furthermore, the lever that controls the
tilling drive must run the tiller only affer
having gone through half of its stroke.
Once the latter has reached stroke end
(working position) the load spring of the
belt-tightener (Fig. 8 detail 1) must leng-
then approx. 6-8 mm. If to obtain these
Fig. 8
conditions, the adjustments are not suf-
ficient (the adjuster has reached bottom
thread) then adjust the trapezoidal belt
by moving the engine along the frame
slots where it is fixed to.
23