Connection - JVC KD-X310BT Manuel D'instructions

Wiring connection
To Blue/white wire of the
wiring harness (D)
To the steering wheel
remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the
supplied power cord (D) as illustrated.
If the unit does not turn on with modified
wiring 1, use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Remote wire (not supplied)
Signal cord (not supplied)
JVC Amplifier
Fuse (10 A)
Microphone input
jack ( 9)
Light blue/yellow
STEERING
WHEEL
REMOTE
If your car does NOT have an
ISO terminal
* Custom wiring harness (separately
purchased)
IMPORTANT: A custom wiring harness
(separately purchased) which is suitable for
your car is recommended for connection.
Front output
Rear/subwoofer output
Antenna terminal
ISO connector
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A6 Orange/white : Car light control switch
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple
: Rear speaker (right)
B2 Purple/black
B3 Gray
: Front speaker (right)
B4 Gray/black
B5 White
: Front speaker (left)
B6 White/black
B7 Green
: Rear speaker (left)
B8 Green/black
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
ENGLISH | 21