JVC KD-X310BT Manuel D'instructions page 15

Bluetooth mode settings
1 Press and hold MENU.
2
Turn the volume knob to select [BLUETOOTH], then press the knob.
3
Turn the volume knob to make a selection (see the following table),
then press the knob.
4
Press MENU to exit.
To return to the previous setting item or hierarchy, press G T/P.
PHONE
Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name.
AUDIO
APPLICATION Shows the connected phone name using the JVC Smart Music Control *
app. " " appears in front of the device name.
1 Turn the volume knob to select a device to delete, then press the
DELETE PAIR
knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PRIORITY Selects a device to be connected as priority device. " " appears in front
of the device name set as priority.
• "NO PAIR" appears if there is no registered device found.
2
P.BOOK WAIT * Copies up to 400 numbers from the phonebook memory of a connected
phone.
SET PINCODE Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
1
Repeat steps
3 Press the volume knob to confirm.
Default: XX
2
and until you finish entering the PIN code.
AUTO CNNCT ON: The unit automatically reconnect when the Bluetooth device is
within range. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; NO: Cancels.
INFORMATION MY BT NAME: Displays the unit name (JVC UNIT). ;
MY ADDRESS: Shows address of this unit.
* 1
JVC Smart Music Control is designed to view JVC car receiver status
and perform simple control operations on Android smart phones.
For JVC Smart Music Control operations, visit JVC website:
<http://www.jvc.net/cs/car/>.
* 2
Selectable only when the connected phone supports OPP.
1
BLUETOOTH®
ENGLISH | 13