Check Before Treatment - NSK M40 XS Manuel D'utilisation

CAUTION
• Disconnect the handpiece only after the motor has completely stopped rotating.
• Connect ONLY to E type Handpiece (ISO 3964).
• After lubrication, stand the handpiece to drain excess oil and wipe off the oil inside the handpiece. Then connect it to the motor.
• After lubrication, do not immediately attach the handpiece to the micromotor. This will avoid micromotor internal damage due to possible infiltration of
excess oil.

5. Check before treatment

Connect the handpiece to the motor and check for motor vibration, noise and overheating. If any abnormalities are found do not use the motor and
contact your Authorized NSK Dealer.
7