Disposal And Recycling; Troubleshooting - Scheppach BASA1 Traduction Des Instructions D'origine

AC motor
• The mains voltage must be 230 - 240 V ~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm .
2
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate

16. Disposal and recycling

Disposing of transport packaging
The packaging protects the machine from damage
during transport. The packaging material is usually
chosen for factors of environmental friendliness and
disposal. It can therefore be recycled. Returning the
packaging to the material life cycle saves raw mate-
rial and reduces waste.
Packaging parts (e.g. plastic sheets, Styropor®) can

17. Troubleshooting

Problem
Motor does not work
The motor starts up
slowly and does not reach
operating speed.
Motor makes excessive
noise
The motor does not reach
its full power.
Motor overheats easily.
Saw cut is rough or
wavy
Workpiece pulls away
and/or splinters
Saw blade is not running
straight
Burn marks appear on the
wood during the cutting
work
Saw blade jams during
cutting work
Possible cause
Motor, cable or plug defective, fuses burnt
Housing cover open (limit switch)
Voltage too low, coils damaged, capacitor
burnt
Coils damaged, motor defective
Circuits in the network are overloaded
(lamps other motors, etc.)
Overloading of the motor, insufficient cool-
ing of the motor
Saw blade dull, tooth shape not appropriate
for the material thickness
Excessive cutting pressure and/or saw
blade not suitable for use
Guide has been wrongly set
Wrong saw blade
Blunt saw blade
Wrong saw blade
Blunt saw blade
Deposits on the saw blade
Guide has been set poorly
be dangerous for children. Risk of choking! Store
packaging parts beyond the reach of children and
dispose of them as soon as possible.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point.
This can occur, for example, by handing it in at an au-
thorised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling of
waste equipment may have negative consequences for
the environment and human health due to potentially
hazardous substances that are often contained in elec-
trical and electronic equipment. By properly disposing
of this product, you are also contributing to the effective
use of natural resources. You can obtain information on
collection points for waste equipment from your munici-
pal administration, public waste disposal authority, an
authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.
Help
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself.
Danger! Check fuses and replace as neces-
sary
Close housing cover exactly
Contact the utility provider to check the volt-
age. Arrange for inspection of the motor by
a specialist. Arrange for replacement of the
capacitor by a specialist
Arrange for inspection of the motor by a
specialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting, re-
move dust from the motor in order to ensure
optimal cooling of the motor
Resharpen saw blade and/or use suitable
saw blade
Insert suitable saw blade
Set the saw blade guide according to the
operating instructions
Select a saw blade according to the operat-
ing instructions
Change the saw blade
Select a saw blade according to the operat-
ing instructions
Change the saw blade
Clean the saw blade
Set the saw blade guide according to the
operating instructions
GB 31