Choosing A Location - Canadian Spa Halifax Manuel D'instructions

CHOOSING A LOCATION

This spa is designed for indoor or outdoor use. Factors to consider
when choosing a location for the spa include: weight of the spa,
indoor/outdoor location and drainage. The following section provides
guidelines that must be followed. It is the sole responsibility of the
spa owner to ensure proper installation of the spa.
IMPORTANT: The base upon which the spa is placed must be
smooth, flat, level and capable of uniformly supporting the combined
weight of the spa, water and users, without shifting or settling, for
the entire time the spa is in place. If the spa is placed on a surface
which does not meet these requirements, damage to the spa skirt
and/or Spa Shell may result. Damage caused by improper support is
not covered by the manufacturer's warranty. It is the responsibility of
the spa owner to ensure the integrity of the supporting structure at all
times. SPA BASE: We recommend a poured, steel reinforced concrete
slab with a minimum thickness of 4 inches (10cm). Wood decking is
acceptable if it is constructed so that it meets the structural
requirements outlined above.
The spa location must provide drainage away from the spa. Placing
the spa in a depression without provisions for proper drainage could
allow rain water, snow melt, overflow and other casual water to flood
the equipment bay, creating a wet condition in which the spa could
be damaged. For spas recessed into a deck, installation must permit
access to the spa access panels, either from above or below for
servicing. Ensure that there are no obstructions which would prevent
removal of all access panels and access to jet components,
especially on the side of the access panels (typically under the
Topside Console).
WEIGHT CALCULATIONS: See spa specifications for exact weights.
Typically the dry weight of a spa can range from 600-1000 lbs (US)
(220-455 kg) dry. The volume of the spa can range from 300-400
gallons US (1135-1515 litres).
Locating your hot tub/spa
OUTDOOR LOCATION
Considerations for selecting an outdoor spa location:
• Proximity to the power source (long length of cable can be
• Local building and home owner association codes pertaining to
• Do not place your spa within 10 ft (3m) of overhead power lines.
• How you intend to use your spa will help you determine where
• If you live in a region where it is cold or rains frequently, place the
• In a cold-weather climate, bare trees will not provide much
• Prevent dirt and contaminants from being tracked into your spa
• Adequate space for spa with accessibility for service (Clearance
• Proper structural support is critical. Consult a licensed
• Drainage: The area in which the spa is placed must have
• Pathway to and from the spa (free of debris, dirt and leaves as
• Closeness to trees and shrubbery (leaves and birds create extra
• Sheltered environment (less wind and weather exposure results
• Proximity to a changing area and shelter (especially in cold
• Environmental factors such as rain, wind, snow and sunlight (run
• Accessibility to children (you should be able to monitor the use
• Cover lift clearance (if you will be installing a cover lift as an
8
expensive)
the installation of a portable spa
Make sure the spa is positioned so that access to the
equipment compartment and all side panels will not be blocked.
Be certain that your installation will meet all relevant local and
national safety codes and requirements.
you should position it. If your spa is mainly used for family
recreation be sure to leave plenty of room around it for activity.
If you will use it for relaxation and therapy, you'll probably want to
create a specific mood around it.
spa near a house entry point
privacy. Think of your spa's surroundings during all seasons to
determine your best privacy options. Consider the view of your
neighbours when you plan the location of your spa
by placing a foot mat at the spa's entrance where the users
can clean their feet before entering your spa. You may also
consider keeping a small water-filled basin nearby for users to
rinse their feet before enter your spa
of 3 ft (1m) around the spa is recommended to permit servicing
the unit)
professional Structural Engineer to determine if the foundation
will adequately support the spa during the entire time it will be in
place, especially if the spa is to be placed on a deck, balcony, roof
or other platform not specifically tied into the main structural
support.
adequate drainage to handle the entire water content of the spa.
In the event of spillage, areas around the spa may become wet;
therefore, all flooring, furniture, walls and adjacent structures
should be able to withstand or resist water and moisture.
not to be tracked into the spa)
cleaning)
in lower operating and maintenance costs)
weather)
off water, as from an unguttered roof overhang, shortens the
life expectancy of the spa cover)
of the spa from the home to prevent unauthorized use by
children; you may want to enclose the spa with a fence or a self
latching gate to prevent unauthorized use)
add on feature, allow 3ft (1m) on all sides of the spa)