Canadian Spa Halifax Manuel D'instructions page 74

1. Unscrew Face Place with
screw driver
3. Slide Face Plate Up
1. Fold Weir Forward
3. Unscrew filter and lift out
4. Clean or exchange filter
5 HP Big Red 2 Speed pump
View Information plate guide for
electrical installation purposes.
TIP: CLEANING YOUR FILTER
It is advisable to clean your hot tub filters every 2 or 3 weeks.
• Turn off spa power
• Remove the cartridge from the filter housing and use a
garden hose or a tap to wash down the filter. Rinse until all
dirt and debris have been removed.
• Dissolve 250 gms of Canadian Spa Filter Free in 10 litres of
luke warm water (one capful holds approximately 30 gms).
USE A PLASTIC PAIL AND MIX UNTIL THE SOLUTION TURNS
RED (ALWAYS READ THE LABEL).
• Soak the filter cartridge for at least 1 hour (overnight is
recommended).
CHANGE A GRATE FILTER ON A CANADIAN SPA TUB
2. Remove Screw
4. Skimmer Exposed
2. Slide basket Out
26
1. Unscrew Face Place with screw driver
2. Remove Screw
1. Slide Face Plate Up
3. Slide Basket Out
5. Unscrew filter and lift out
• Rinse the cartridge again after cleaning to remove any
traces of cleaning solution.
• Always dry the filters before inserting them back into your
hot tub. This ensures that the filters perform to their best
and last longer. Let them dry naturally. It is also a good idea
to keep a spare set of filters.
• Do not run spa without filters
To order more filters call 1-877-347-7727 or visit our website:
www.canadianspacompany.com
3. Slide Face Plate Up
2. Skimmer Exposed
4. Skimmer Exposed
2 HP 2 speed pump
View Information plate guide for
electrical installation purposes.