Button Functions - Canadian Spa Halifax Manuel D'instructions

HOW JETS WORK
Air is mixed with the water by using the air controls to create massage(s) of varying degrees. Water flow is adjusted by simply turning the
outer face of the full sized jets. Our hot tubs have a combination of pulsating, rotating, and directional adjustable jets.
2" Directional jet
Adjustable and interchangeable jet features a
directional nozzle. The jet can be removed by
turning it counter-clockwise. To replace the
jet push inward and clockwise until it clicks
into place.
2" Adjustable jet
Adjustable and interchangeable jet features a
directional nozzle. The jet can be removed by
turning it counter-clockwise. To replace the
jet push inward and clockwise until it clicks
into place.
2" LED jet (Black/Chrome)
Adjustable and interchangeable jet features a
directional nozzle. The jet can be removed by
turning it counter-clockwise. To replace the
jet push inward and clockwise until it clicks
into place.
3" LED jet (Black/Chrome)
Adjustable and interchangeable jet features a
directional nozzle. The jet can be removed by
turning it counter-clockwise. To replace the
jet push inward and clockwise until it clicks
into place.
OTHER FEATURES
Large Diverter
Located on the topside of the spa, this valve
physically diverts the flow of water from one
jet zone of the spa to the other.
Air Controller
These are located around the top of your
spa. Increase or decrease the force of your
jets by opening or closing the air control
valves.
PUMPS
FLIP (INVERT DISPLAY)
Press the dedicated Flip/Invert
Allows the user to flip the display with a single
button press.
JETS
Press the "Jets 1" button once to turn pump 1 on or off, and to shift
between low- and high-speeds. If left running, the pump will turn off
after a time-out period. The pump 1 low-speed will time out after 30
minutes. The high-speed will time out after 15 minutes.
The low-speed of pump 1 runs when the blower or any other pump
is on. If the spa is in Ready Mode Pump 1 low may also activate for
at least 1 minute every 30 minutes to detect the spa temperature
(polling) and then to heat to the set temperature if needed. When the
low-speed turns on automatically, it cannot be deactivated from the
panel, however the high speed may be started.
JETS 1, JETS 2, JETS 3
NEEDS ANNOTATING
5 HP Big Red 2 Speed pump
Our 5 HP pump is the most
powerful spa pump in the
market with our oversize
intakes.

BUTTON FUNCTIONS

button.
4" LED jet (Black/Chrome)
Adjustable and interchangeable jet features a
directional nozzle. The jet can be removed by
turning it counter-clockwise. To replace the
jet push inward and clockwise until it clicks
into place.
5" LED jet (Black/Chrome)
Adjustable and interchangeable jet features a
directional nozzle. The jet can be removed by
turning it counter-clockwise. To replace the
jet push inward and clockwise until it clicks
into place.
Circulation Jet
Supplies Ozone and heated water from the
circulation pump.
5" (Jumbo) Directional jet
Adjustable and interchangeable jet features
a directional nozzle. The jet can be removed
by turning it counter-clockwise. To replace
the jet push inward and clockwise until it
clicks into place.
Aroma basket cap
Open cap to place aromatherapy beads.
Close after use.
Waterfall control
Located on the topside of the spa, this valve
adjusts water flow to the waterfall.
LIGHTS
Press light button to turn on and off the lights. Each consecutive press
will alternate through different lighting modes and colours.
PRESS TO CHANGE LIGHT SETTINGS
ADJUST TEMPERATURE
When using a panel with Up and Down buttons (Temperature
buttons), pressing Up or Down will cause the temperature to flash.
Pressing a temperature button again will adjust the set temperature
in the direction indicated on the button. When the LCD stops flashing,
the spa will heat to the new set temperature when required. The
temperature can be set between 60°F (15 °C) and 104°F (40 °C).
TEMPERATURE UP
PRESS-AND-HOLD
If a Temperature button is pressed and held when the temperature is
flashing, the temperature will continue to change until the button is
released.
6
2" LED Fountain jet
Fixed jet operates with pump 2 providing
colourful fountain from the perimeter of
the spa.
3" Directional jet (Chrome)
Adjustable and interchangeable jet features
a directional nozzle. The jet can be removed
by turning it counter-clockwise. To replace
the jet push inward and clockwise until it
clicks into place.
4" Directional jet (Chrome)
Adjustable and interchangeable jet features
a directional nozzle. The jet can be removed
by turning it counter-clockwise. To replace
the jet push inward and clockwise until it
clicks into place.
3" LED Cup Light
Cup light to provide exterior lighting and
provide a nice effect when a plastic cup is
placed on it.
EVA Pillow
Eva pillow are design not to absorb water and
make the ritght choice of material for pillows.
Our pillows are back lit with LED lighting.
2 HP 2 speed pump
Our 2 HP pump with its 2.5"
intake delivers 25% more
volume of water then standard
pumps with 2 inch intake
TEMPERATURE DOWN