Installation & Setup - Canadian Spa Halifax Manuel D'instructions

PRE-DELIVERY SETUP
A standard Canadian Spa Company hot tub will be delivered to your curb, standing on its side and securely strapped to a pallet (the
swim spa models will arrive via flatbed truck). Ensure that you will have sufficient means to move your spa to your desired location
(dolly, forklift, crane etc). The spa cannot be disassembled and will require sufficient clearance to move it (refer to table below for spa
dimensions).
For Swim Spa owners: Your spa will arrive as a single unit on a flatbed truck and will require a crane or other mechanical method of unloading
to get the spa to your location. We recommend that you hire a professional lifting company to assess the situation and organise the move for
you. Canadian Spa Company will not take any responsibility for moving the spa because the spa warranty does not cover damage incurred
from unloading. We recommend a 6" (15cm) re-enforced concrete pad as a suitable base for your swim spa.
Failure to properly locate your spa may void your warranty, please contact your local Canadian Spa Company Dealer if you have any questions.
POWERING UP YOUR SPA
Once the spa is properly wired and filled with water, the
spa power can be turned on and Start-up chemicals added.
1. Turn on RCD breaker. If breaker trips immediately check
wire connections. Upon initial power up, 4 sets of numbers flash
on the LED display of the topside Console. The last number in the
sequence is the incoming power meter which can be used to verify
that the spa is wired correctly.
2. IMPORTANT: To avoid pump damage, do not run pumps
for more than 1 minute without moving water. If no water is
moving, turn the power off and perform air lock procedure.
3. The Topside Console display flashes"--F" for approximately
2 minutes to determine water temperature as it flows through the
heater.
4. The default pre-set temperature is 100F. The last measured
temperature is constantly displayed on the LCD readout. This
temperature will be current only when the pump has been
running for at least 2 minutes. Set the desired temperature
between 80-104°F (26- 40°C) by pressing the temp button(s).
If the water temperature is below the set temperature, the spa's
heater and heat indicator light will turn on. All features of
the Topside Console will be available. The spa will heat
approximately 1° every 30 minutes per 1,000 litres.
5. Check for leaks! Although spas are fully checked at the factory,
shipping & delivery might cause a leak. Remember to pay
particular attention to barrel unions adjoining the heater.
Contact your Canadian Spa dealer directly if there is a problem.
If your new spa pump does not prime (flow) on the initial start-up you
may be experiencing an "air lock".
This normal occurrence can be easily corrected by loosening the
plumbing union on the suction side of the Jet or Circulation Pump until
water flows into the pump and all air is expelled.
PRESS BUTTONS SLOWLY FOR FIRST RUN WHEN STARTING UP
Installation & Setup
Starting your hot tub/spa
12
The above photograph refers to plug and play models only