Pc Diagnostic Tool; Checking The Bios Configuration (Only V2.2.1 - V2.2.3) - Dentsply Sirona CEREC AC Connect Notice D'utilisation

Dentsply Sirona
Operating Instructions for the Acquisition Unit - With CEREC Omnicam
66 37 479 D3492
D3492.201.07.28.02 09.2019
10

PC Diagnostic Tool

10.1 Checking the BIOS configuration (only V2.2.1 -
V2.2.3)
Check the BIOS configuration before using the PC diagnostic tool. If the
configuration is set incorrectly, the PC diagnostic tool will not recognize
the hard drive and cannot check it. The PC diagnostic tool then
registers errors for tests 14 and 15.
1. Call up the UEFI/BIOS by repeatedly pressing the "Delete" button
during start up.
2. Activate the relevant side with the RIGHT/LEFT cursor buttons or by
clicking the "Advanced" tab with the mouse.
3. Select the "Onboard Devices Configuration" option there.

10.1 Checking the BIOS configuration (only V2.2.1 - V2.2.3)

10 PC Diagnostic Tool
77