Switching The Units Off - Dentsply Sirona CEREC AC Connect Notice D'utilisation

6 Installation and startup
6.4 Initial startup
36
Operating Instructions for the Acquisition Unit - With CEREC Omnicam
NOTE
Possible data loss and PC malfunction:
Switching the exposure unit off at the ON button during operation may
cause data loss and PC malfunctions.
➢ Always switch the unit off as described in the chapter "Switching
the units off".
3. Switch the monitor on.
4. After loading the operating system, start the CEREC Connect
application by double-clicking on the CEREC Connect icon.
5. For descriptions of further software actions, an online help function
can be invoked with "F1" or via the Help... menu option.
NOTE
Internet Explorer V 5.0 or higher must be installed on your system in
order to use the online help function.
NOTE
In order to prevent data security breaches, it is recommended that
users enable the password-protected login function for the Windows
operating system.
6.4.8

Switching the units off

NOTE
Proper shutdown procedure
The operating system must always be shut down properly to prevent
data loss.
1. Exit all programs.
2. Power down the operating system.
Ä The PC automatically switches off. The operating state LED
lights up yellow.
NOTE
Do not switch off while battery (optional) is being charged
The battery will only be charged if the power cord is plugged in and
the main switch at the back of the unit is switched on (see also
"Charging the battery (optional) [→ 73]").
3. Switch the acquisition unit off at the main switch.
or
➢ Remove the connector of the power cord from the power supply.
For this purpose, it is necessary to position the unit in such a way
that the power connection it is always accessible.
Ä The operating state LED goes out.
Switch the unit off at least once a day.
Dentsply Sirona
66 37 479 D3492
D3492.201.07.28.02 09.2019