Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Dentsply Sirona
Operating Instructions for the Acquisition Unit - With CEREC Omnicam
66 37 479 D3492
D3492.201.07.28.02 09.2019
NOTE
Install only approved software
To prevent interference with the runtime reliability of the program,
only approved software may be installed.
➢ Use the current version ≥ CEREC Connect software 4.x.
NOTE
Ventilation openings must not be obstructed.
4.1.4
Movement and stability of the unit
NOTE
The unit can overturn or slip away
For reasons of tilt stability, the unit must be pulled by its front handle
when being moved. If you push the unit, obstacles on the floor could
block its wheels, thus causing it to overturn.
The two front wheels of the unit have brakes which can be locked to
ensure secure positioning. If the unit is steeply inclined or standing on
a slippery surface and lateral forces are acting on it, it may slide even
though the wheel brakes are locked.
➢ Always make sure that the unit's footprint is a flat, nonskid
surface.
4.1.5
Maintenance and repair
As manufacturers of dental instruments and laboratory equipment, we
can assume responsibility for the safety properties of the unit only if the
following points are observed:
● The maintenance and repair of this unit may be performed only by
Dentsply Sirona or by agencies authorized by Dentsply Sirona.
● Components which have failed and influence the safety of the unit
must be replaced with original (OEM) spare parts.
● Only original cables may be used, so that EMC requirements are
met.
Please request a certificate whenever you have such work performed. It
should include:
● The type and scope of work.
● Any changes made in the rated parameters or working range.
● Date, name of company and signature.
4.1.6
Modifications to the product
Modifications to this product which may affect the safety of the operator,
patients or third parties are prohibited by law!
4 Safety
4.1 Basic safety information
13
Publicité
Chapitres
Table des Matières
Dépannage
