Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en-us
Prepare Installation Space
Combining several Vario devices: The connecting strip
VA 420 000/010 is required for the combination of
several Vario appliances. This is available separately as a
special accessory. Consider additional space
requirement for the connecting strip between the
appliances when making the cut-out (see installation
instructions VA 420 000/010).
Appliances can also be installed in individual cut-outs,
bearing in mind a minimum distance between the devices
of 2" (51 mm).
Drilled Hole for Control Knob
Possible types of installation:
Installation in the front of the base cabinet
▯
Installation in the countertop next to the appliance
▯
Installation in the countertop in front of the appliance
▯
Note: Follow the installation instructions provided for the
control knobs.
Ventilation
To guarantee that the appliance works correctly, the
cooktop MUST be sufficiently ventilated.
Since the ventilation in the lower section of the appliance
requires a sufficient supply of fresh air, the cabinet must
be designed accordingly. The following is required for
this:
8
A minimum clearance between the rear of the
▯
cupboard and the kitchen wall, and between the
surface of the worktop and the upper area of the
drawer.
An opening at the top to the rear of the cupboard.
▯
If the minimum clearance of
▯
provided at the rear of the cupboard, you must create
an opening on the underside.
Note: If the appliance is installed in an island unit or
another installation that is not described here, you must
ensure that the cooktop is sufficiently ventilated.
4
05
4
05
25
/
inch (20 mm) is not
32
Publicité
Chapitres
Table des Matières
