Change Capacity; Set Checking Weighing; Set Beep Mode; Set A/D Speed - Baxtran BS-TRI Manuel D'utilisation

7.7 CHANGE CAPACITY*

After enter setting mode, display shows "F0 CAL", press
press the key change current capacity.
7.8 SET CHECKING WEIGHING FUNCTION
After enter setting mode, display shows "F0 CAL", press
press key select the checking weighing function on/off, press

7.9 SET BEEP MODE

After enter setting mode, display shows "F0 CAL", press
press key select the beep mode (0,1,2), press

7.10 SET A/D SPEED

After enter setting mode, display shows "F0 CAL", press
enter,press key select the A/D speed (7.5/15/30), press

7.11 SET MULTI-TARE FUNCTION*

After enter setting mode, display shows "F0 CAL", press
press key select Multi-Tare function on/off. press
7.12 RESET FACTORY SETTINGS*
After enter setting mode, display shows "F0 CAL", press
factory settings.

8. BATTERY OPERATION

When battery voltage low, the battery indication (
on. To charge the battery simply plug into the AC adapter. The scale does not need to be turned on.
There is an LED above display window to indicate the status of battery charging. If the LED is green the battery has a full
charge. If it is red indicates the battery is being charged.
As the battery is used it may fail to hold a full charge. If the battery life becomes unacceptable then contact your distributor.

9. ERROR CODE

Error Message Description
----- Maximum load exceeded
Incorrect date
Err 1
Incorrect time
Err 2
Zero setting error
Err 4
Key board error
Err 5
A/D value out of range
Err 6
key until display shows "F5 CAP", press
key until display shows "F6 ck", press
key to sure.
key until display shows "F7 bep", press
key to sure.
key until display shows "F8 SPD", press
key to sure.
key until display shows "F9 tar", press
key to sure.
key until display shows "F10 rt", press
)will turn on. The battery should be charged as soon as the arrow is
Solution
Unload or reduce weight
Enter the date by using format "yy;mm:dd"
Enter the time by using format "hh:mm:ss"
Zero setting range exceeded due to switching on.(4%max) Make sure
platform empty.
Check the keys and connecter.
Make sure platform empty and check the pan is installed proper.
Check the load cell connectors.
USER'S MANUAL BS-TRI
key to enter,
key to enter,
key to enter,
key to
key to enter,
key to reset
EN
7