Ventilation And Air Supply - CombiSteel 7455.0900 Mode D'emploi

4.3 NOMINAL GAS CONSUMPTION
Burner (Each) kW
Note: Pressure test point is located at the gas manifold of the top section.
Table (A) shows the gas type for each country in Europe.
4.4 TEST POINT PRESSURE
The pressure test point is located on the gas manifold. The gas manifold and pressure test point is accessed by
removing the gas valve control knobs and the front panel. The test point pressure is shown in the Nominal Gas
Consumption Table.
4.5

VENTILATION AND AIR SUPPLY

All gas burners and pilots require sufficient air to operate. For optimum performance and for your safety, it is
ESSENTIAL that the equipment, in the installed position, has the proper air and ventilation and the correct
exhaust/canopy and air balance. The correct installation and compliance with all regulatory and other
requirements is the responsibility of the purchaser/owner.
Please note that a strong exhaust canopy will create a vacuum if there is insufficient replacement air. The amount
of air exhausted must be replaced by an equal amount of air.
Airflow to the appliance must not be blocked or restricted (e.g. large objects should not be placed in front of the
appliance). The flue must never be covered or restricted in any way.
I2H, I2E, I2E+ I2 (43.46 – 45.3 MJ/m3 (0°C))
9.0
www.combisteel.com
I3+, I3B/P30
9.0
I3B/P50
7.5 7.5
8