Cleaning And Maintenance; Circuit Diagram - CombiSteel 7455.1600 Mode D'emploi


Rotate the ratio machine clockwise to the maximum position which is normal heating place that shows
heating tube works from the beginning to the end but not heats in circulation way.

The oven with two temperature controllers can accord needs to heat separately or at the same time the
operation is as easy as the operation of a temperature controller.

After finishing operation, rotate the temperature controller to off position at reverse direction. Then
plug off the equipment and cut down the power.

If the power cord is damaged, user should ask the professionals to change the same model and
specification power cord.

Cleaning and maintenance


Cut off power before cleaning to prevent from accident.

The stainless drop plate and drop net can be taken out to clean with water with non-corrosive cleaner.
But do not use sharp knife to get rid of filth on the surface of oven.

After finishing operation, user can use wet towel containing non-corrosive cleaner to scrub the surface
of oven and power cord. Do not spray water directly to clean body of oven in case of water leakages
into controlling trunk and destroy electric function and elevating structure.

If user does not use it at any time, user should shut power switch and temperature controller in time.

While the equipment is not used for a long period, user should clean the oven and put it in a well-
ventilated warehouse with no corrosive gas.
WARNING!
This appliance shall not be cleaned with a water jet.

Circuit diagram

HL1, HL3—POWER INDICATOR
HL2, HL4—HEATING INDICATOR
ST, ST1, ST2—TEMPERATURE CONTROLLER
EH, EH1, EH2—ELECTRIC HEATING TUBE
E—GROUND-CONNECTION
www.combisteel.com
6