Oven Burner - CombiSteel 7455.0900 Mode D'emploi

5.3 GRILL (GRIDDLE) BURNER(S)
Pilot Flame Ignition
Starting from the OFF ● position, press the control knob and rotate to the PILOT ★ position.


Press the control knob and then stick the flame gun through a hole of about 0.6" diameter to ignite the
pilot. The pilot is located 7" inside of the hole. Look in the pilot window to ensure that the pilot is lit
up. The pilot flame can be viewed through the front panel). Keep the knob fully depressed for 15
seconds after the pilot lights.

Release the knob and check the pilot flame stays alight. If the pilot flame did not stay alight, repeat
the ignition procedure.
Grill (Griddle) Burner Ignition

Slightly depress the control knob and rotate to the desirable level.

When the automatic valve senses that the pilot is alight, the gas flow to the main burner is opened.
Pilot Standby Position

To turn the main burner off and keep the pilot ON, slightly depress the control knob and rotate to the
PILOT ★ position.
Shut Down/Pilot OFF

Slightly depress the control knob and rotate to the OFF ● position.
NOTE: If the pilot flame were accidentally extinguished, the flame failure safety device would operate and cut
the gas flow to the main burner. It would then be necessary to re light the pilot by following the above procedure.
5.4

OVEN BURNER

WARNING: ENSURE THE PILOT IS ESTABLISHED BEFORE TURNING ON THE THERMOSTAT.

Before attempting to light the appliance, the cover, if so equipped, shall be opened.

Make sure the thermostat located on the control panel is turned off.

Take off the lower panel, press the black button of the safety valve for 15 to 30 seconds. Stick the flame
gun through an opening to light up the pilot (located at about 100 mm behind the opening). Wait for 5
to 10 seconds before releasing your finger on the black button. Repeat the above process again if the
pilot flame does not stay by now.

When the pilot flame is lit, turn the thermostat to the desired temperature 121℃ to 287℃ (250 – 550
You can observe the flame of the oven burner from an opening behind the lower panel. You may replace
the lower panel now.

To turn off the oven, rotate the thermostat clockwise to "OFF" position. The oven burner should go out
immediately. A 5 minute complete shutoff period should be allowed before the appliance is relighted.
Adjustment of main burners

Proper flame setting of main burners is obtained by loosening set screw on air shutters and to proceed
as follows:

Air shutters should first be opened all the way for a sharp blue flame, then slowly close until the flames
turns soft with just a minimum of yellow at the tips.
THE PILOT FLAME CAN BE SEEN THROUGH THE VIEWING HOLE.
www.combisteel.com
o
F).
10