Hach SL1000 Manuel D'utilisation De Base page 13

Figure 8 Probe connections
Complete probe measurements
Do the procedure that follows to complete a measurement with probe(s). Refer to
Chemkey measurements can be completed at the same time. Refer to
measurements on page 11.
1. Calibrate the probes before initial use. Refer to
Note: For the best accuracy, calibrate the probes daily.
2. Set the date and time in the meter before the probe is attached. Refer to
time on page 10.
The probe must have the correct service-life time stamp.
3. If complete traceability is necessary, enter a site ID and operator ID before measurement. Refer
to Use an operator ID
4. Remove the probe connector port caps and attach the probe(s). Refer to
the probe connection.
Note: Do not discard the probe connector port caps. Install the probe connector port caps again when no probe
is connected.
5. Rinse the sample flasks with sample.
6. Fill the sample flask with sample so that the sensor is fully in the sample.
7. Put the probe(s) into the probe sample flasks and push Read if the measurement mode is set to
Press to Read. Refer to the probe documentation for more information.
8. The measurement values are shown on the display.
on page 10 and Use a site ID
Complete Chemkey
Calibrate the probe on page 14.
on page 10.
Figure 9. Multiple
Change the date and
Figure 8 on page 13 for
English 13