Panasonic CS-Z20VKEW Comment Utiliser L'appareil page 23

Connection network using WPS mode (method 1)
Press the "WPS" button from the
1
router that will be connected to an air
conditioner.
• Check the status of Wireless LAN LED
on the remote control. If the Wireless
LAN LED is OFF, press the Wireless
LAN button to enable the Wireless
LAN connection.
Connection Guide
Step 1
When the connection of air conditioner
3
to router is successful, the Wireless LAN
LED changed from blinking to ON.
Connection Guide
Step 1
When the connec on of air-condi oner to router
is successful, the Wireless LAN LED changes from
blinking to ON.
*It may take up to few minutes before changes
to ON.
If the Wireless LAN LED is ON, tap "Next".
If Wireless LAN LED keep blinking, tap "Check"
Step 2 Step 3
Next
Cancel
Step 3
Step 2
Next
Check
Cancel
Ensure Wireless LAN LED is ON. Press
2
and hold the Wireless LAN
for 5 seconds until "1" is shown on the
remote control and press
to the air conditioner.
Connection Guide
Step 1
If Wireless LAN LED is OFF during the connec on
setup, please press "Wireless LAN" bu on once
to enable the Wireless LAN before proceeding to
step 1 .
1. Press and hold "Wireless LAN" bu on for 5 secs
un l easy se ng " 1 " is shown .
2. Point remote control to air-condi oner and
press "SET" bu on once.
3. A er step 1 & 2 have been done, tap "Next".
If the Wireless LAN LED keep blinking,
4
check the wireless router connection.
Connection Guide
Step 1
Searching for air-condi oner.
Please wait...
button
pointing
SET
Step 3
Step 2
SET
CANCEL
Next
Cancel
Step 2 Step 3
Cancel
23