Hitachi NR 90AD Manuel D'instructions Et De Sécurité page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. ALWAYS WEAR EAR AND HEAD
PROTECTION.
Always wear ear protection to protect
your ears from loud noise.
Always wear head protection to protect
your head from flying objects.
8. STORE NAILER PROPERLY.
When not in use, the Nailer should be
stored in a dry place. Keep out of reach of
children. Lock the storage area.
9. KEEP WORK AREA CLEAN.
Cluttered areas invite injuries. Clear all work
areas of unnecessary tools, debris, furniture,
etc.
10. NEVER
USE
FLAMMABLE LIQUIDS OR GASES.
The Nailer produces sparks during
operation.
Never use the Nailer in sites containing
lacquer, paint, benzine, thinner, gasoline,
gases, adhesive agents, and other
materials which are combustible or
explosive.
11. KEEP VISITORS AWAY.
Do not let visitors handle the Nailer.
All visitors should be kept safely away
from work area.
12. DRESS PROPERLY.
Do not wear loose clothing or jewelry as
they can be caught in moving parts.
Rubber gloves and nonskid footwear are
recommended when working outdoors.
Wear protective hair covering to contain
long hair.
13. NEVER USE NON RELIEVING COUPLER
ON NAILER.
If a non relieving coupler is used on the
Nailer, the Nailer can remain charged
with air after disconnecting and thus will
be able to drive a fastener even after
disconnecting.
The Nailer and air hose must have a hose
coupling such that all pressure is removed
from the Nailer when the coupling joint is
disconnected.
14. CHECK PUSH LEVER BEFORE USE.
Make sure the push lever operates
properly. (The push lever may be called
"Safety".) Never use the Nailer unless
SAFETY
IN
PRESENCE
— Continued
WARNING
the push lever is operating properly,
otherwise the Nailer could drive a fastener
unexpectedly. Do not tamper with or
remove the push lever, otherwise the
push lever becomes inoperable.
15. KEEP ALL SCREWS AND COVERS
TIGHTLY IN PLACE.
Keep all screws and covers tightly
mounted.
periodically.
Never use the Nailer if parts are missing
or damaged.
16. DO NOT LOAD FASTENERS WITH
TRIGGER OR PUSH LEVER DEPRESSED.
When loading fasteners into the Nailer or
OF
when connecting the air hose,
1) do not pull the trigger;
2) do not depress the push lever; and
3) keep the Nailer pointed downward.
17. KEEP HANDS AND FEET AWAY FROM
FIRING HEAD DURING USE.
Never place your hands or feet closer
than 8 inches (200 mm) from the firing
head.
A serious injury can result if the fasteners
are deflected by the workpiece, or are
driven away from the point of entry.
18. PLACE
WORKPIECE.
Do not drive fasteners on top of other
fasteners or with the Nailer at too steep of
an angle; the fasteners can ricochet and
hurt someone.
19. BEFORE STARTING WORK, CHECK THE
NAILING OPERATION SWITCHING
DEVICE.
This Hitachi nailer includes a nailing
operation switching device.
Before starting work, check the setting of
the operation switching device.
If the switching device is not set properly,
the nailer will not operate correctly.
20. BE CAREFUL OF DOUBLE FIRE DUE TO
RECOIL.
If the push lever is unintentionally allowed
to re-contact the workpiece following
recoil, an unwanted fastener will be
driven.
In order to avoid this undesirable double
fire,
Check
their
NAILER
PROPERLY
English
condition
ON
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nr 90ae

Table des Matières