EdilKamin NANCY Installation, Usage Et Maintenance page 30

1st ignition/test by the Edilkamin authorised Dealer
Start-up must be carried out as prescribed by point 3.21 of
standard UNI 10683.
This standard indicates the control operations to be carried out
in situ, aimed at ascertaining correct system function.
Before igniting.
You must consult the Edilkamin DEALER in your area
when igniting the stove for the fi rst time, in order for the
stove to be calibrated according to the type of pellets and
installation conditions, thereby validating the warranty.
There may be a slight smell of paint the fi rst few times it is
ignited, however, this will disappear quickly.
Before igniting you must check:
• that installation is correct
• the power supply
• that the door closes properly to a perfect seal
(inner righthand door).
• that the combustion chamber is clean
• that the display is on standby (the date, power or temperature
fl ashes).
Filling the pellet hopper
To access the hopper, open the left cast iron semi-top (A -
fi g.1) and remove the lid underneath (B - fi g. 2).
NOTE:
1) gently accompany the semi-top during opening and
closing.
2) use the glove supplied when fi lling the stove whilst it is
running and therefore is hot.
NOTE regarding the fuel.
NANCY is designed and programmed to burn wood pellets
with 6 mm diameter.
Pellets are a type of fuel in the form of little cylinders, made
from compacted sawdust, compressed under high pressure
with no adhesives or foreign materials.
They are sold in bags of 15 kg.
For the stove to function properly, you MUST NOT burn
anything else in it. Using other materials (including wood)
will render the warranty null and void. Such use is detected by
laboratory analyses. Edilkamin has designed, tested and pro-
grammed their stoves to guarantee the best performance when
pellets with the following characteristics are used:
diameter: 6 millimetres
maximum length: 40 mm
maximum moisture content: 8%
calorifi c value: at least 4300 kcal/kg.
INSTRUCTIONS FOR USE
- 30
A
fi g. 1
B
fi g. 2
If pellets with different characteristics are used, the stoves
must be recalibrated a similar procedure to that carried out by
the DEALER when the stove is ignited the fi rst time.
Using unsuitable pellets may: decrease effi ciency; cause
malfunctions; stop the stove from functioning due to clogging,
dirt on the glass, unburnt fuel, etc.
A simple, visual analysis of the pellets may be carried out:
Good quality: smooth, uniform length, not very dusty.
Poor quality: with longitudinal and transverse cracks, very
dusty, various lengths and mixed with foreign matter.
-