Ego Power+ HT2400 Guide D'utilisation page 138

 Make sure that the cord is located so that it will not be stepped on, tripped
over, come in contact with sharp edges or moving parts, or otherwise be
subjected to damage or stress. this will reduce the risk of accidental falls,
which could cause injury and damage to the cord, which could then result in
electric shock.
 Keep the cord and charger from heat to prevent damage to housing or
internal parts.
 do not allow gasoline, oils, petroleum-based products, etc. to come in
contact with plastic parts. these materials contain chemicals that can damage,
weaken, or destroy plastic.
 do not operate the charger with a damaged cord or plug, which could cause
shorting and electric shock. if damaged, have the charger repaired or replaced
by an authorized service technician at an egO service center.
 do not operate the charger if it has received a sharp blow, been dropped,
or has otherwise been damaged in any way. take it to an authorized service
technician for an electrical check to determine if the charger is in good working
order.
 do not disassemble the charger. take it to an authorized service technician
when service or repair is required. incorrect reassembly may result in a risk of
electric shock or fire.
 Unplug the charger from the electrical outlet before attempting any
maintenance or cleaning to reduce the risk of electric shock.
 disconnect charger from the power supply when not in use. this will reduce
the risk of electric shock or damage to the charger if metal items should fall into
the opening. it will also help prevent damage to the charger during a power surge.
 risk of electric shock. do not touch the uninsulated portion of output connector
or uninsulated battery terminal.
 Save these instructions. refer to them frequently and use them to instruct
others who may use this tool. if you lend this tool to someone else, also lend these
instructions to them to prevent misuse of the product and possible injury.
10
56V standard charger — ch2100