Clear The Codes; Customizing Data Items - tecnotest EZ-SCAN 4000 Manuel D'utilisation

__________________________________________________________________________ EZ-SCAN 4000
3.5 -

Clear the codes

•
Clearing Trouble Codes will remove any Trouble Codes from the vehicle's
computer. You can use this feature to make sure vehicle repairs were done
correctly by doing a new scan after clearing the codes.
•
Your vehicle must be scanned before clearing trouble codes. If DATA is pressed,
and the vehicle has not been scanned, the scanner will display Press the Scan
key to Scan New Data. Refer to "Scanning the Vehicle" on chapter 3.0.
•
Make sure the EZ-Scan 4000 scanner cable is correctly connected to the scanner
and to the vehicle, the engine is OFF, and the vehicle ignition key is ON, then press
POWER.
•
Press DATA to display the Data menu.
•
[OBD-II] Use the
press ENTER.
•
ENTER to Clear will be displayed on the screen. Press ENTER to clear all the
codes in the vehicle's computer (pressing DATA again will take the unit out of
Data mode and display the opening screen).
•
After the codes have been cleared, Function Successful will be displayed.
Press DATA to display the opening screen.
3.6 -

Customizing data items

•
Make sure you have completed a vehicle scan. Then press POWER.
•
Press DATA to display the Data menu. Use the
5-Customize Data, then press ENTER.
•
You may select or deselect all the data items displayed, by pressing ENTER.
When you are finished, only the data items you have selected will appear when
viewing the Operational Data, Monitoring Real Time Data and Capture Mode
Data – up to 20 data items.
OPERATING INSTRUCTIONS
and arrow keys until 4-Clear Codes is high lighted, then
and arrow keys until

45