Configure The Scanner For Your Vehicle; Set The Display Units (Sae/Metric) - tecnotest EZ-SCAN 4000 Manuel D'utilisation


EZ-SCAN 4000 ___________________________________________________________________________
2.2 -

Configure the Scanner for Your Vehicle

Before the scanner is used, it must be configured for your specific vehicle. Don't worry,
it only takes a few steps.
•
Press POWER to turn the unit ON, then press CONFIG.
•
Make sure 1-Config Unit is displayed on the screen, then press ENTER.
•
Use the arrow keys until the correct vehicle manufacturer name is highlighted,
then press ENTER to select it (select OBD-II Generic if your specific OBD-II
manufacturer is not listed).
•
Use the arrow keys to select the year of the vehicle, then press ENTER.
NOTE:
After the unit is configured, it will Initialize then display the opening screen. Continue
with Section 3 (chapter 2.3) to set the display units.
•
Depending on the vehicle selected, you may be asked some additional questions to
complete the configuration process. Use the arrow keys to highlight the correct
answer, then press ENTER to select it.
2.3 -

Set the Display Units (SAE/Metric)

The EZ-SCAN scanner can be set up to display in SAE or Metric units. The default
setting is SAE. Go to Section 4 (chapter 2.4) if you do not need to change the display
units.
•
To change the unit of measure, press CONFIG from the initial screen.
•
Use the arrow keys until 2-System Config is displayed, then press ENTER.
•
Use the arrow keys to select 1-SAE/Metric, then press ENTER.
•
Use the and
to select the highlighted choice (or press the CONFIG Key to Cancel and return to
the initial screen).
38
arrow keys to select 1-SAE or 2-METRIC then press ENTER
OPERATING INSTRUCTIONS