Setup/Operating Instructions; Install New Batteries - tecnotest EZ-SCAN 4000 Manuel D'utilisation

__________________________________________________________________________ EZ-SCAN 4000
2.0 -

SETUP/OPERATING INSTRUCTIONS

This section gives the information you need to set up and operate your EZ-SCAN
Scanner:
•

Install New Batteries.

•
Configure the Scanner for Your Vehicle.
•
Set the Display Units (SAE/Metric).
•
Connect the Scanner to Your Vehicle.
2.1 - Install New Batteries
The EZ-SCAN Scanner is powered by 4 AA batteries. Before the scanner is used the first
time, you need to install batteries in the unit.
Make sure the batteries are put in according to the diagram on the back of the battery
compartment door. Refer to the illustration below.
•
If the screen becomes too dim to view, the batteries need to be replaced.
Replace all four batteries to avoid unit malfunction. When it is time to change the
batteries, the Data Holder Feature will save all Data and configuration
information if fresh batteries are installed immediately after removing the old ones.
CAUTION:
Leaving used or dead batteries in the scanner beyond the battery date may
result in damage to the unit.
•
As long as good batteries are in the scanner, the vehicle engine configuration and
data will remain in the scanner's memory, even after the unit is powered off.
•
Operational data, Trouble Codes, and all remaining scanned information will
remain in memory until the unit is reconfigured. A Power Miser Feature
automatically powers the unit OFF after 30 minutes of no activity.
OPERATING INSTRUCTIONS

37