Getting Started - Hama Cube Mode D'emploi

4. Getting started

4.1 Inserting the batteries
Open the battery compartment (13), remove the contact breaker and then
close the battery compartment (13).
4.2. Replacing the batteries
• Open the battery compartment (13), remove and properly dispose of the
dead batteries and insert two new AAA batteries with the correct polarity.
Replace the battery compartment (13) cover.
5. Operation
5.1 Automatic date/time setting using the DCF signal
• Once you have inserted the battery, the display is switched on, an acoustic
signal sounds and the alarm clock automatically starts searching for a DCF
signal. During the search, the radio symbol
• Once radio signal receiving is successful, the display shows the symbol
"radio tower" continuously.no ashing. This process can take 7 to 5 minutes.
• When the wireless signal is received, the date and time are automatically set.
Display ashing
Display steady
Not displayed
Note – Cancellation of search process
• The search for the DCF signal can be cancelled by pressing the +/RCC button (10).
• Then set the time and date as described in 5.2 Manually setting the date/time.
4
Display
ashes.
Searching for the DCF signal
Active
Successful - signal reception
Inactive – no signal reception