Getting Started; Setting The Time Manually - Hama 00186317 Mode D'emploi

Warning – Batteries
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the environment. They can
contain toxic, environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using the device in extreme temperatures and extremely low
atmospheric pressure (for example, at high altitudes).

4. Getting Started

Open the battery compartment cover, remove the contact breaker and then close the battery
compartment cover again.
5. Operation
5.1. Automatic time setting using the DCF signal
• Once you have removed the contact breaker, an acoustic signal sounds and the alarm clock
automatically starts searching for a DCF signal.
• After approx. 5-10 minutes (depending on how quickly the radio signal was received), the hands will
set themselves to the correct time.

5.2. Setting the time manually

• If the correct time has not been set after approx. 10 minutes, this means the clock could not nd
a DCF signal.
• Press and hold the M.SET button to manually set the correct time. Release the M.SET button once
you have reached the required time.
• The clock automatically continues to search for the DCF signal on a daily basis. If the signal is
received successfully, the manually set time is overwritten.
• You may need to change the installation location and avoid areas with possible sources of interfer-
ence (cordless and mobile telephones, wireless speakers, etc.).
5.3. Starting manual reception
• Once the clock is running, press the REC button for 3 seconds. This will set the hands to the 12:00
position. Now the clock starts searching for the DCF signal.
• If no signal has been received, the clock will show the time previously saved.
5.4. Alarm
Setting the alarm
• Move the setting wheel on the back of the alarm clock to set the required alarm time.
• To activate/deactivate the alarm, move the slide switch to the ON or OFF position.
3