Backlight; Warranty Disclaimer - Hama 00186317 Mode D'emploi

• The status indicator next to the third digit is red when the alarm is activated and green when it is
deactivated.
Stopping the alarm/snooze function
• If the alarm is activated, it is triggered at the set time and an alarm signal sounds for two minutes
with increasing volume. The alarm automatically stops after this time and is then triggered again at
the set alarm time.
• To stop the alarm early, move the slide switch to the OFF position.
• Move the slide switch back to the ON position to activate the alarm for the set alarm time.
Note – Snooze function
• While the alarm signal is sounding, press the SNOOZE/LIGHT button to activate the snooze
function. The alarm signal will be stopped for 5 minutes, after which it will sound again.
• The snooze function can be activated six consecutive times.

5.5. Backlight

• If you press the SNOOZE/LIGHT button, the clock face will light up for approx. 5 seconds.
6. RESET function:
• If, for whatever reason, the clock has not been set correctly, you can reset it.
• Use a metal object (such as a needle) to short-circuit the clock by means of the ‚RESET' button on
the rear side. All hands will move to the 12:00 position.
• After approx. 5-10 minutes (depending on how quickly the signal was received), the hands will
automatically set themselves to the correct time.
7. Care and Maintenance
Only clean this product with a slightly moist, lint-free cloth, and do not use aggressive cleaning agents.
Make sure that water does not get into the product.

8. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
9. Technical Data
Power supply
4
Elegance Pro radio-controlled alarm clock
1.5 V, 1 AA battery