Electric Connection - SCHOLTES SST2 Mode D'emploi

Installing your appliance
220-240 V ~ single-phase line
10A fuse or differential
standard IEC 60083

ELECTRIC CONNECTION

The appliance must be fitted correctly to guarantee electrical
safety. During fitting and maintenance operations, the appli-
ance must be unplugged from the electrical grid; fuses must be
switched off or removed.
The electrical connections are made before the appliance is
installed in its housing.
Ensure that:
- the electrical installation has sufficient voltage,
- the electrical wires are in good condition,
- the diameter of the wires complies with the installation
requirements.
Your oven must be connected with a (standardised) power
cable with three conductors of 1 mm2 (1ph + 1N + ground)
which must be connected to a 220-240V ~ single-phase grid via
a 1ph + 1 neutral + ground IEC 60083 standardised power
socket or via an all-pole cut-off device in compliance with the
installation rules.
circuit breaker
2 pole electrical
outlet + ground
Power cable
approximately
1.5 m in length
20A single-phase
220-240V ~ 50Hz counter
Warning
The safety wire (green-yellow) is connected to
the appliance's terminal
connected to the ground lead of the electrical
set-up.
In the case of connection to an electric wall
socket, it must remain accessible after
installation.
A 10 Amp fuse must be used in the installation.
If the power cable is damaged, it must be
replaced by the manufacturer, its After-Sales
Service Department or a similarly qualified
person to avoid danger.
and must be
3
GB