Dometic PerfectView CAM 301 Instructions De Montage Et De Service page 8

Safety and installation instructions
If you disconnect the negative terminal of the battery, all data stored in the volatile memories will
be lost.
•
The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Note the following instructions during installation:
•
Secure the parts of the camera installed in the vehicle in such a way that they cannot become
loose under any circumstances (sudden braking, accidents) or cause injuries to the occu-
pants of the vehicle.
•
Secure any parts of the system concealed by the bodywork in such a manner that they cannot
be come loose or damage other parts or cables, or impair vehicle functions (steering, pedals,
etc.).
•
To prevent damage when drilling, make sure there is sufficient space on the other side for the
drill head to come out (fig. 1, page 2).
•
Deburr all drill holes and treat them with a rust-protection agent.
•
Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be performed by
qualified specialists.
Observe the following instructions when working with electrical parts:
•
When testing the voltage in electrical cables, only use a diode test lamp or a voltmeter.
Test lamps with a bulb consume too much voltage, which can damage the vehicle's electronic
system.
•
When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 2, page 2).
•
Insulate all connections.
•
Secure the cables against mechanical stress with cable binders or insulating tape, for example,
to existing lines.
8
PerfectView
EN