Safety And Installation Instructions - Dometic PerfectView CAM 301 Instructions De Montage Et De Service

PerfectView
2

Safety and installation instructions

The manufacturer accepts no liability for damage in the following cases:
•
Damage to the product resulting from mechanical influences and incorrect connection voltage
•
Alterations to the product without express permission from the manufacturer
•
Use for purposes other than those described in the operating manual
Please observe the prescribed safety instructions and stipulations from the vehicle
manufacturer and service workshops.
!
WARNING!
Inadequate supply cable connections could result in short circuits, causing:
•
Cable fires
•
The airbag being triggered
•
Damage to electronic control equipment
•
Electrical malfunctions (indicators, brake light, horn, ignition, lights)
A
NOTICE!
To prevent the risk of short circuits, always disconnect the negative terminal of the
vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should also be discon-
nected.
Therefore, please observe the following instructions:
•
When working on the following cables, use only insulated cable lugs, plugs and tab sleeves.
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use porcelain wire connectors.
•
Use a crimping tool to connect the cables. For permanent connections, you can solder the
cable ends together and then insulate them.
•
Screw the cable when connecting cable 31 (earth)
– Screw on the cable using a cable terminal and serrated washer to one of the vehicle's earth
bolts or
– screw the cable to the bodywork using a cable terminal and a self-tapping screw.
Make sure there is a good earth connection.
EN
Safety and installation instructions
7