Videotec MAXIMUS MLX Manuel D'instructions page 8

• Make sure that all the equipment are certified for
the application and for the environment in which
they will be installed.
• Any change that is not expressly approved by the
manufacturer will invalidate the guarantee.
DANGER!
High level hazard.
Risk of electric shock. Disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.
• Make sure that the power is off when installing or
carrying out maintenance, with the circuit-breaker
open.
• A power disconnect device must be included
in the electrical installation, and it must be very
quickly recognizable and operated if needed.
• The electrical system to which the unit is
connected must be equipped with a 10A max
automatic bipolar circuit breaker. The minimum
distance between the circuit breaker contacts
must be 3mm (0.1in). The switch must be
equipped with protection against overcurrent
(circuit breaker).
• The device can only be considered to be
switched off when the power supply has been
disconnected and the connection cables to other
devices have been removed.
• Be careful not to use cables that seem worn or old.
• All the cables must comply with IEC60332-1-2, IEC
60332-1-3 and IEC/EN60079-14.
• When commencing installation make sure that
the specifications for the power supply for the
installation correspond with those required by the
device.
• For continued protection against risk of fire,
replace only with same type and rating of fuse.
Fuses must be replaced only by service personnel.
• This equipment is not suitable for use in locations
where children are likely to be present.
6
DANGER!
Emission of visible light or infrared.
Can be harmful for eyes. Pay attention to
the provided indications.
• Do not stare at the lamp when on. Can be harmful
for eyes.
• CAUTION! The infrared LED illuminator emits high-
intensity visible light. In compliance with standard
EN62471/IEC62471, the photobiological safety
assessment has classified the device in Risk Group
2, where it exceeds the values of the Exempt
Group. The risk linked to the observer depends on
how the product has been installed and is used.
For installation, follow the instructions in this
manual. Do not look directly at the illuminator
using optical lenses. Exposure hazard values
(EHV): 29s. Hazard distance (HD): 200mm.
• CAUTION! The white light LED illuminator emits
high-intensity visible light. In compliance with
standard EN62471/IEC62471, the photobiological
safety assessment has classified the device
in Risk Group 2, where it exceeds the values
of the Exempt Group. The risk linked to the
observer depends on how the product has been
installed and is used. For installation, follow the
instructions in this manual. Do not look directly
at the illuminator using optical lenses. Exposure
hazard values (EHV): 27.2s. Hazard distance (HD):
200mm.
MNVCMLX_2222_EN