6.4 Connector board description
BOARD DESCRIPTION
Connec-
Function
tor/
Terminal
J1
Power supply line (24Va
c/24Vdc)
J5
I/O
J8
PoE+ power supply
F1
Fuse
Tab. 4
F1
J1
Fig. 16
18
Terminals - Nominal
section of the cables
used
from 1.0mm² (17AWG)
up to 2.5mm² (12AWG)
from 0.2mm² (24AWG)
up to 1.0mm² (17AWG)
–
–
J5
J8
6.5 Connecting the power supply
6.5.1 Connecting the power supply
(24Vac/24Vdc)
Check that the power supply socket and
cable are adequately dimensioned.
The polarity of the voltage, applied to the
power terminal, is irrelevant.
The power supply cable must be covered
by the silicone sheath (01) supplied. The
silicone sheath must be fastened with the
corresponding cable tie (02).
Fig. 17
The power supply cables should be connected to the
power supply terminal of the housing board (J1, 6.4
Connector board description, page 18).
01
02
MNVCMLX_2222_EN