Product Description And Type Designation; Preparing The Product For Use; Safely Disposing Of Packaging Material - Videotec UEI Manuel D'instructions

4 Identification
4.1 Product description and type
designation
LED illuminator for ULISSE EVO, wavelength available
850nm, 940nm and white light.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Illuminator
• Cabling for illuminator connection
• Instruction manual
MNVKUEI_2222_EN
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
6 Installation
Before starting any operation, make sure
the power supply is disconnected.
This product can only be installed on the
PTZ of the ULISSE EVO line. No calibration
required for light beam alignment with the
camera.
Remove the cover on the upper part of the PTZ,
unscrewing the relevant screws.
Fig. 1
3