Identification; Product Description And Type Designation; Product Markings - Videotec GEKO IRN Manuel D'instructions

• Installation category (also called Overvoltage
Category) specifies the level of mains voltage
surges that the equipment will be subjected to.
The category depends upon the location of the
equipment, and on any external surge protection
provided. Equipment in an industrial environment,
directly connected to major feeders/short branch
circuits, is subjected to Installation Category III. If
this is the case, a reduction to Installation Category
II is required. This can be achieved by use of an
insulating transformer with an earthed screen
between primary and secondary, or by fitting
listed Surge Protective Devices (SPDs) from live
to neutral and from neutral to earth. Listed SPDs
shall be designed for repeated limiting of transient
voltage surges, suitable rated for operating voltage
and designated as follows: Type 2 (Permanently
connected SPDs intended for installation on the
load side of the service equipment overcurrent
device); Nominal Discharge Current (In) 20kA min.
For example: FERRAZ SHAWMUT, STT2240SPG-
CN, STT2BL240SPG-CN rated 120Vac/240Vac,
(In=20kA). Maximum distance between installation
and reduction is 5m.
• This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be required
to take adequate measures.
• To comply with the main supply voltage dips and
short interruption requirements, use a suitable
Uninterruptable Power Supply (UPS) to power the
unit.
• In the case of a 24Vac power supply, you must
provide for adequate separation from the AC
power supply line using double or reinforced
insulation between the main power supply line
and the secondary circuit.
MNVCIRN_1420_EN

4 Identification

4.1 Product description and type
designation
State of the art illuminator, which provides high
reliability and excellent image quality. The GEKO
lights the entire scene evenly, eliminating hotspots
and underexposures, for unbeatable night-time
images and secure surveillance of the area. The high
efficiency heat sink body ensures maximum LED
durability and protection against over-temperatures,
whereas the front glass, made of special
technopolymer, provides high infrared transmittance.
The illuminators are protected against electrostatic
discharges.
The illuminator is available in versions 24Vac/12-
24Vdc or 100-240Vac with integrated power supply.
GEKO is supplied with a wall-mount bracket that
rotates horizontally and vertically.
The GEKO infrared illuminator guarantee is 5 years,
while for GEKO with the white light is 2 years.

4.2 Product markings

See the label attached to the product.
5